Hammond Enclosures - 1422 MD Series - Multiple Door Enclosures

1422 MD Series Multiple Door Enclosures
NEMA 12 - Continuous Hinge, Padlockable Doors

Application

Designed to house electrical, electronic, hydraulic or pneumatic controls and instruments.
Provides a degree of protection from falling dirt, dust, oil and water.

Standards

Construction

Formed 10 gauge steel.
Smooth, continuously welded seams without knockouts, cutouts or holes.
Heavy duty body stiffeners are provided for extra rigidity.
Reinforced eyebolts are provided for easy enclosure lifting.
Double door openings have gasketed overlapping doors, eliminating the need for a center post.
Continuously hinged doors may be removed by pulling the hinge pin.
Doors are secured with a three point latch and operated with a vault type padlocking handle.
Latch rods are equipped with rollers for easier door closing.
Oil resistant gaskets are permanently secured and mechanically retained.
Removable 10 gauge inner panels are included in the enclosures.
3 door units have 2 panels (34" x 78" and 70" x 78").
4 door units have 2 panels (70" x 78" each).
5 door units have 3 panels (one 34" x 78" and two 70" x 78").
Slave doors have mechanical interlock and cannot be opened unless the master door is open.
Panel supports are provided in enclosures for easy panel installation.
Collar studs are provided for mounting inner panels.
A grounding stud is provided in the enclosure for each door and a bonding stud is provided on the door.
A literature pocket is provided for the inside of the door.

Finish

Cover and enclosure are finished in recoatable smooth ANSI 61 gray powder coating on the outside, with white powder coating on the inside.
Removable inner panels are finished in white powder coating.

Accessories (Contact us at 262-446-0000 for more information)